Dell POWEREDGE M1000E - Manual (Page 158)

158 Command Groups
Telnet Server
show system power Displays information about the system level
power consumption.
UE or PE
show system
temperature
Displays information about the system
temperature and fan status.
UE or PE
show tech-support Displays system and configuration information
(for debugging/calls to technical support).
PE
show users Displays information about the active users. PE
show version Displays the system version information. UE
stack Sets the mode to Stack Global Configuration
mode.
GC
stack-port Sets the mode to Stack Global Configuration
mode to configure Stack ports as either
Stacking ports or as Ethernet ports.
All of the stack-port commands in Stack
Configuration mode are not supported by the
PCM8024 and PCM8024-k switches.
GC
standby Configures the standby in the stack. SG
switch renumber Changes the identifier for a switch in the stack. GC
telnet Logs into a host that supports Telnet. PE
traceroute Discovers the IP routes that packets actually
take when travelling to their destinations.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Command Description Mode a
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
ip telnet server disable Enables/disables the Telnet service on the
switch.
GC
ip telnet port Configures the Telnet service port number on
the switch.
GC
show ip telnet Displays the status of the Telnet server and the
Telnet service port number.
PE
Command Description Mode a
2CSPC4.XModular-SWUM200.book Page 158 Thursday, March 10, 2011 11:18 AM