Dell POWEREDGE M1000E - Manual (Page 715)

TACACS+ Commands 715
console(config)#tacacs-server key @#$%^&*()_+=-
{}][<>.,/';:|
tacacs-server timeout
Use the tacacs-server timeout command in Global Configuration mode to set
the interval during which a switch waits for a server host to reply. To restore
the default, use the no form of this command.
Syntax
tacacs-server timeout [ timeout ]
no tacacs-server timeout
• timeout — The timeout value in seconds. (Range: 1–30)
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the timeout value as 30.
console(config)#tacacs-server timeout 30
timeout
Use the timeout command in TACACS Configuration mode to specify the
timeout value in seconds. If no timeout value is specified, the global value is
used.
Syntax
timeout [ timeout ]
2CSPC4.XModular-SWUM200.book Page 715 Thursday, March 10, 2011 11:18 AM