Syntax, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 699: User guidelines, Example, Spanning-tree mst cost, Spanning-tree mst, Cost
Spanning Tree Commands
699
Syntax
spanning-tree mst configuration
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
For two or more switches to be in the same MST region, they must have the
same VLAN mapping, the same configuration revision number and the same
name.
Example
The following example configures an MST region.
console (config)#spanning-tree mst configuration
console (config-mst)#instance 1 add vlan 10-20
console (config-mst)#name region1
console (config-mst)#revision 1
spanning-tree mst cost
Use the spanning-tree mst cost command in Interface Configuration mode
to configure the internal path cost for multiple spanning tree (MST)
calculations. If a loop occurs, the spanning tree considers path cost when
selecting an interface to put in the forwarding state. To return to the default
port path cost, use the no form of this command.
Syntax
spanning-tree mst
instance-id
cost
cost
no spanning-tree mst
instance-id
cost
•
instance-ID —
ID of the spanning -tree instance. (Range: 1-15)
2CSPC4.XModular-SWUM200.book Page 699 Thursday, March 10, 2011 11:18 AM