Dell POWEREDGE M1000E - Manual (Page 448)

448 IGMP Snooping Commands
Default Configuration
The default group membership interval time is 260 seconds.
Command Mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures an IGMP snooping group membership
interval of 520 seconds.
console(config-vlan)#ip igmp snooping
groupmembership-interval 2 520
ip igmp snooping maxresponse
This command sets the IGMP Maximum Response time on a particular
VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not
receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3174 seconds.
The no form of this command sets the maximum response time on the VLAN
to the default value.
Syntax
ip igmp snooping maxresponse vlan-id seconds
no ip igmp snooping maxresponse vlan-id
• vlan-id — Number assigned to the VLAN.
• seconds — IGMP Maximum response time in seconds. (Range: 1-3174)
Default Configuration
The default maximum response time is 10 seconds.
2CSPC4.XModular-SWUM200.book Page 448 Thursday, March 10, 2011 11:18 AM