Example, Show ip pim rp hash, Syntax – Dell POWEREDGE M1000E User Manual
Page 1044: Default configuration
1044
Multicast Commands
Example
(console)#show ip pim neighbor vlan 10
Up Time
Expiry Time
Neighbor Addr
Interface
hh:mm:ss
hh:mm:ss
--------------- ---------- --------- -----------
192.168.10.2 VLAN0010 00:02:55 00:01:15
(FASTPATH) #show ip pim neighbor
Neighbor Addr Interface Uptime Expiry Time
(HH:MM::SS) (HH:MM::SS)
--------------- --------- ----------- -----------
192.168.10.2 VLAN0001 00:02:55 00:01:15
192.168.20.2 VLAN0010 00:03:50 00:02:10
If no neighbors are learned on any of the interfaces, the following message is
displayed.
No neighbors are learned on any interface.
show ip pim rp hash
The show ip pim rp hash command displays the rendezvous point (RP)
selected for the specified group address.
Syntax
show ip pim rp hash
group-address
•
group-address
— A valid multicast address supported by RP.
Default Configuration
There is no default configuration for this command.
2CSPC4.XModular-SWUM200.book Page 1044 Thursday, March 10, 2011 11:18 AM