Dell POWEREDGE M1000E - Manual (Page 1086)

1086 OSPF Commands
Default Configuration
1 second is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 40-second transmit-delay interval.
console(config-router)#area 10 virtual-link
192.168.2.2 transmit-delay 40
auto-cost
By default, OSPF computes the link cost of each interface from the interface
bandwidth. The link cost is computed as the ratio of a “reference bandwidth”
to the interface bandwidth (ref_bw / interface bandwidth), where interface
bandwidth is defined by the “bandwidth” command. Because the default
reference bandwidth is 100 Mbps, OSPF uses the same default link cost for all
interfaces whose bandwidth is 100 Mbps or greater. To change the reference
bandwidth, use the auto-cost command, specifying the reference bandwidth
in megabits per second. The different reference bandwidth can be
independently configured for OSPFv2 and OSPFv3.
Syntax
auto-cost reference-bandwidth ref_bw
• ref_bw — The reference bandwidth in Mbps (Range: 1–4294967).
Default Configuration
The default reference bandwidth is 100 Mbps.
Command Mode
OSPFv2 or OSPFv3 Router Configuration mode.
2CSPC4.XModular-SWUM200.book Page 1086 Thursday, March 10, 2011 11:18 AM