Dell POWEREDGE M1000E - Manual (Page 489)

IPv6 MLD Snooping Commands 489
ipv6 mld snooping groupmembership-interval
The ipv6 mld snooping groupmembership-interval command sets the MLD
Group Membership Interval time on a VLAN or interface. The Group
Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before
deleting the interface from the entry. This value must be greater than the
MLDv2 Maximum Response time value. The range is 2 to 3600 seconds.
Syntax
ipv6 mld snooping groupmembership-interval [vlan-id] [seconds]
no ipv6 mld snooping groupmembership-interval [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
• seconds — MLD group membership interval time in seconds. (Range: 2-
3600)
Default Configuration
The default group membership interval time is 260 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-4/0/1)#ipv6 mld snooping
groupmembership-interval 300
ipv6 mld snooping maxresponse
The ipv6 mld snooping maxresponse command sets the MLD Maximum
Response time for an interface or VLAN. The Maximum Response time is the
amount of time in seconds that a switch will wait after sending a query on an
2CSPC4.XModular-SWUM200.book Page 489 Thursday, March 10, 2011 11:18 AM