Dell POWEREDGE M1000E - Manual (Page 1275)

Captive Portal Commands 1273
Captive Portal Global Commands
authentication timeout
Use the authentication timeout command to configure the authentication
timeout. If the user does not enter valid credentials within this time limit, the
authentication page needs to be served again in order for the client to gain
access to the network. Use the “no” form of this command to reset the
authentication timeout to the default.
Syntax
authentication timeout timeout
no authentication timeout
• timeout —The authentication timeout (Range: 60–600 seconds).
Default Configuration
The default authentication timeout is 300 seconds.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#authentication timeout 600
console(config-CP)#no authentication timeout
captive-portal
Use the captive-portal command to enter the captive portal configuration
mode.
2CSPC4.XModular-SWUM200.book Page 1273 Thursday, March 10, 2011 11:18 AM