Dell POWEREDGE M1000E - Manual (Page 1075)

OSPF Commands 1075
Default Configuration
The default role is candidate.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator role of the NSSA.
console(config-router)#area 20 nssa translator-role
always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPF
Configuration mode to configure the translator stability interval of the NSSA.
Syntax
area area-id nssa translator-stab-intv integer
no area area-id nssa translator-stab-intv
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
• integer — The period of time that an elected translator continues to
perform its duties after it determines that its translator status has been
deposed by another router. (Range: 0–3600)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
2CSPC4.XModular-SWUM200.book Page 1075 Thursday, March 10, 2011 11:18 AM