Dell POWEREDGE M1000E - Manual (Page 558)

558 Multicast VLAN Registration Commands
User Guidelines
This command statically configures a port to receive the specified multicast
group on the specified VLAN. This command only applies to receiver ports in
compatible mode. It also applies to source ports in dynamic mode. In
dynamic mode, receiver ports can also join multicast groups using IGMP
messages.
Example
console(config-if-Gi1/0/1)#interface Te1/1/1
console(config-if-Gi1/0/24)#switchport mode trunk
console(config-if-Gi1/0/24)#switchport trunk native vlan
2000
console(config-if-Gi1/0/24)#switchport trunk allowed vlan
add 2000
console(config-if-Gi1/0/24)#mvr
console(config-if-Gi1/0/24)#mvr type source
console(config-if-Gi1/0/24)#mvr vlan 2000 group 239.1.1.1
show mvr
Use the show mvr command in Privileged EXEC mode to display global MVR
settings.
Syntax
show mvr
Parameter Description
The following table explains the output parameters.
Parameter Description
MVR Running MVR running state. It can be enabled or
disabled.
MVR Multicast VLAN Current MVR multicast VLAN. It can be in
the range from 1 to 4094.
2CSPC4.XModular-SWUM200.book Page 558 Thursday, March 10, 2011 11:18 AM