Dell POWEREDGE M1000E - Manual (Page 948)

948 IPv6 PIM Commands
ipv6 pim spt-threshold
Use the ipv6 pim spt-threshold command to set the multicast traffic
threshold rate for the last-hop router to switch to the shortest path on the
router. Use the no form of this command to return the threshold to its default
value (0).
Syntax
ipv6 pim spt-threshold spt-threshold
no ipv6 pim spt-threshold
Parameter Description
Default Configuration
The default threshold rate is 0. This indicates that the multicast router
should always switch to the multicast source tree.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim spt-threshold 1000
ipv6 pim ssm
Use the ipv6 pim ssm command to administratively configure PIM Source
Specific Multicast (SSM) range of addresses for IPv6 multicast routing. Use
the no form of this command to removed configured ranges of addresses from
the router.
Parameter Description
spt-threshold The multicast traffic threshold rate in kilobytes per second.
Range: 0–2000 Kbps.
2CSPC4.XModular-SWUM200.book Page 948 Thursday, March 10, 2011 11:18 AM