Dell POWEREDGE M1000E - Manual (Page 1138)

1138 OSPF Commands
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console(config)#show ip ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
------------- ------------- ---------- -----------------
0.0.0.1 Normal 1 Enable
show ip ospf virtual-link
Use the show ip ospf virtual-link command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all.
Syntax
show ip ospf virtual-link [ area-id neighbor-id ]
• area-id — Identifies the OSPF area whose ranges are being displayed.
(Range: IP address or decimal from 0–4294967295)
• neighbor-id — Identifies the neighbor’s router ID. (Range: Valid IP
address)
Default Configuration
Show information for all OSPF Virtual Interfaces.
2CSPC4.XModular-SWUM200.book Page 1138 Thursday, March 10, 2011 11:18 AM