Storm-control broadcast, Syntax, Default configuration – Dell POWEREDGE M1000E User Manual

Page 400: Command mode, User guidelines, Example, Storm-control multicast

Advertising
background image

400

Ethernet Configuration Commands

storm-control broadcast

Use the storm-control broadcast command in Interface Configuration mode

to enable broadcast storm recovery mode for a specific interface. If the mode

is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast

traffic ingressing on an interface increases beyond the configured threshold,

the traffic will be dropped. Therefore, the rate of broadcast traffic will be

limited to the configured threshold.

Syntax

storm-control broadcast [level |

rate

]

no storm-control broadcast

• level— The configured rate as a percentage of link-speed.

rate

— The configured rate in kilobits per second (kbps). (Range: 0-100)

Default Configuration

The default value is 5.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

This command has no user guidelines.

Example

console(config-if-1/0/1)#storm-control broadcast

level 5

storm-control multicast

Use the storm-control multicast command in Interface Configuration mode

to enable multicast storm recovery mode for an interface. If the mode is

enabled, multicast storm recovery is active, and if the rate of L2 multicast

traffic ingressing on an interface increases beyond the configured threshold,

the traffic will be dropped. Therefore, the rate of multicast traffic will be

limited to the configured threshold.

2CSPC4.XModular-SWUM200.book Page 400 Thursday, March 10, 2011 11:18 AM

Advertising