Altera Quartus II Settings File - Manual (Page 772)

T8_DELAY0
Specifies the propagation delay for T8 Delay Cell. This is an advanced option that should be used only
after you have compiled a project, checked the I/O timing, and determined that the timing is
unsatisfactory. For detailed information on how to use this option, refer to the data sheet for the device
family. This option is ignored if it is applied to anything other than an input or bidirectional pin.
Type
Integer
Device Support
This setting can be used in projects targeting any Altera device family.
Notes
This assignment supports Fitter wildcards.
Syntax
set_instance_assignment -name T8_DELAY0 -to <to> -entity <entity name>
<value>
772 T8_DELAY0
MNL-Q21005
2015.05.04
Altera Corporation Quartus Settings File Reference Manual
Send Feedback