Brocade Network OS Command Reference v4.1.0 - Manual (Page 1095)

Network OS Command Reference 1057
53-1003115-01
show running-config interface tengigabitethernet bpdu-drop
2
show running-config interface
tengigabitethernet bpdu-drop
Displays the BPDU drop status of a 10-gigabit Ethernet interface.
Synopsis show running-config interface tengigabitethernet [rbridge-id/slot/port] bpdu-drop [enable]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
enable Displays the drop status of STP/MSTP/RSTP and PVST+/R-PVST+ BPDUs.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display information about dropped BPDUs on the specified 10-gigabit
Ethernet interface.
Usage Guidelines STP, RSTP, or MSTP must be configured.
Brocade Network OS v4.1.0 supports PVST+ and R-PVST+only. The PVST and R-PVST protocols are
proprietary to Cisco and are not supported.
Examples To display BPDU drop status information for a specific 10-gigabit Ethernet port:
switch# show running-config interface tengigabitethernet 1/0/49 bpdu-drop
See Also interface