Ip route next-hop-enable-default – Brocade Network OS Command Reference v4.1.0 User Manual
Page 434

396
Network OS Command Reference
53-1003115-01
ip route next-hop-enable-default
2
ip route next-hop-enable-default
Enables the default route for next-hop resolution.
Synopsis
ip route next-hop-enable-default
no ip route next-hop-enable-default
Operands
There are no operands for this command.
Defaults
Disabled
Command Modes
RBridge ID configuration mode
Description
Use this command to enable a Brocade device to use the default route (0.0.0.0/0) to resolve a
next hop.
This command works independently from the ip route next-hop-recursion and
ip route next-hop ospf commands. If the default route is a protocol route, that protocol needs to be
enabled to resolve static routes using the ip route next-hop ospf command. If the default route
itself is a static route, you must configure the ip route next-hop-recursion command to resolve
other static routes by this default route.
Usage Guidelines
Enter no ip route next-hop-enable-default to disable the default route for next-hop resolution.
Examples
To enable the default route for next-hop resolution:
switch (config)# rbridge-id 30
switch (config-rbridge-id-30)# ip route next-hop-enable-default
See Also
ip route next-hop-recursion, ip route next-hop ospf, ip route next-hop-vrf