Brocade Network OS Command Reference v4.1.0 - Manual (Page 427)

Network OS Command Reference 389
53-1003115-01
ip pim-sparse
2
ip pim-sparse
Enables or disables Protocol Independent Multicast Sparse Mode on a physical or a VE interface.
Synopsis ip pim-sparse
no ip pim-sparse
Operands None
Defaults Protocol Independent Multicast (PIM) is not enabled on an interface.
Command Modes Interface configuration mode
Router interface configuration mode
Description Use this command to enable or disable Protocol Independent Multicast Sparse Mode on a physical
or a VE interface.
Usage Guidelines Enter no ip pim-sparse to disable this feature.
Examples Enabling sparse PIM on an interface
switch(conf-if-ext-0/15)# ip pim-sparse
See Also router pim