Brocade Network OS Command Reference v4.1.0 - Manual (Page 402)

364 Network OS Command Reference
53-1003115-01
ip igmp snooping mrouter-timeout
2
ip igmp snooping mrouter-timeout
Configures the mrouter timeout value for Internet Group Management Protocol (IGMP) snooping.
Synopsis ip igmp snooping mrouter-timeout seconds
no ip igmp snooping mrouter-timeout
Operands seconds Timeout time in seconds. Valid range is from 1 through 60000 seconds.
Defaults 300 seconds
Command Modes VLAN interface configuration mode
Description Use this command to set the timeout range for when multicast router ports are automatically
learned on a specific VLAN interface.
Usage Guidelines Enter no ip igmp snooping mrouter-timeout to restore the default mrouter value of 300 seconds on
the VLAN interface.
Examples To configure the mrouter timeout value to 600 seconds on a VLAN interface:
switch(config)# interface vlan 100
switch(config-Vlan-100)# ip igmp snooping mrouter-timeout 600
See Also interface, ip igmp snooping enable (global version), show ip igmp snooping,
ip igmp snooping enable, ip igmp snooping fast-leave, ip igmp snooping mrouter,
ip igmp snooping querier enable