Brocade Network OS Command Reference v4.1.0 - Manual (Page 245)

Network OS Command Reference 207
53-1003115-01
default-passive-interface (OSPF)
2
default-passive-interface (OSPF)
Marks all OSPF interfaces passive by default.
Synopsis default-passive-interface
no default-passive-interface
Operands None
Defaults None
Command Modes OSPF VRF router configuration mode
Description Use this command if you want all OSPF interfaces marked passive by default.
You can use the ip ospf active and ip ospf passive commands in interface subconfiguration mode
to change active/passive state on specific OSPF interfaces.
Usage Guidelines Use the no form of this command to disable it.
Examples To mark all OSP interfaces as passive for a specified RBridge:
switch# configure
switch(config)# rbridge-id 1
switch(config-rbridge-id-1)# router ospf
switch(config-router-ospf-vrf-default-vrf)# default-passive-interface
See Also None