Neighbor filter-list (bgp) – Brocade Network OS Command Reference v4.1.0 User Manual
Page 537
Network OS Command Reference
499
53-1003115-01
neighbor filter-list (BGP)
2
neighbor filter-list (BGP)
Specifies a filter list to be applied to updates from or to the specified neighbor.
Synopsis
neighbor {ip-address | peer-group-name} filter-list ip-prefix-list-name [in | out]
no neighbor {ip-address | peer-group-name} filter-list ip-prefix-list-name [in | out]
Operands
ip-address
IPv4 address of the neighbor
peer-group-name
Peer group name configured by the neighbor peer-group-name command.
ip-prefix-list-name
Name of the filter list.
in
Specifies that the list is applied on updates received from the neighbor.
out
Specifies that the list is applied on updates sent to the neighbor.
Defaults
None
Command Modes
BGP address-family IPv4 unicast configuration mode
Description
Use this command to specify a filter list to be applied to updates from or to the specified neighbor.
Usage Guidelines
Use the no form of the command to restore the defaults.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# neighbor 10.11.12.13 filter-list myfilterlist out
See Also
None