Sfp breakout – Brocade Network OS Command Reference v4.1.0 User Manual
Page 720
682
Network OS Command Reference
53-1003115-01
sfp breakout
2
sfp breakout
Displays the QSFP port breakout configurations.
Synopsis
sfp breakout
no sfp breakout
Operands
None
Defaults
Breakout mode is set to disabled.
Command Modes
Connector configuration mode
Description
Use this command to display the QSFP port breakout configuration for the specified QSFP ports.
Usage Guidelines
This command is an executable command and it could be executed under connector mode.
This command is destructible and irreversible. After this command, you must execute the “copy
running-config startup-config” command, and immediately perform a power-cycle on the
corresponding linecard/switch.
Use the no sfp breakout to disable breakout mode and create a single Fo interface.
Examples
To enable SFP breakout on a connector:
switch(config)# hardware
switch(config-hardware)#connector 2/0/1
switch(config-connector-2/0/1)# sfp breakout
To disable SFP breakout on a connector:
switch(config-connector-2/0/1)# no sfp breakout
See Also
show running-config hardware connector, connectorpower-off linecard, power-on linecard