Lldp profile, Dp profile, Profile – Brocade Network OS Command Reference v4.1.0 User Manual
Page 464
426
Network OS Command Reference
53-1003115-01
lldp profile
2
lldp profile
Applies a Link Layer Discovery Protocol (LLDP) profile to an interface.
Synopsis
lldp profile name
no lldp profile
Operands
name
Specifies the profile name. Valid profile name length is between 1 and
32 characters.
Defaults
LLDP profile name.
Command Modes
Interface subtype configuration mode
Description
Use this command to apply a Link Layer Discovery Protocol (LLDP) profile to a specific interface.
Usage Guidelines
You must use the profile command to create an LLDP profile before you can apply the profile to the
interface. Only one LLDP profile can exist at any time for a particular interface. When this
command is not present, the parameters defined in the global LLDP configuration are used.
Enter no lldp profile to delete the profile from the interface.
Examples
To apply an LLDP profile called test on an specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# lldp profile test
See Also
interface, lldp dcbx-version, lldp disable, lldp iscsi-priority