Brocade Network OS Command Reference v4.1.0 - Manual (Page 97)

Network OS Command Reference 59
53-1003115-01
capture packet interface
2
NOTE
The all option is not supported for enabling packet capture.
To view the captured information on the switch, use the show capture packet interface command.
Note the following limitations:
• Support is provided only on physical interfaces (1-, 10-, and 40-gigabit Ethernet), not on
logical interfaces. To see packets on logical interfaces, first enable the capture on the
corresponding physical interfaces.
• In the initial release, support for capturing transit traffic requires ACL logging.
• Packets that are dropped in the ASIC cannot be captured.
CAUTION
Capturing packets over multiple sessions and over long durations can affect system
performance.
Examples
switch# capture packet interface tengigabitethernet 166/0/1 direction both
filter all
See Also show capture packet