Brocade Network OS Command Reference v4.1.0 User Manual
Page 239
Network OS Command Reference
201
53-1003115-01
debug vrrp
2
port
Specifies a valid port number.
ve vlan_id
Specifies the VLAN number for a virtual Ethernet (VE) interface.
packets recv
Debugs packets received.
packets sent
Debugs packets sent.
session VRID
Specifies the virtual group ID to debug. Valid values range from 1
through 128.
Defaults
None
Command Modes
Privileged EXEC mode
Description
Use this command to enable or disable debugging for VRRP traffic. You can, for example, capture
event and packet information for all virtual groups or for a specific interface.
Usage Guidelines
This command is for VRRP and VRRP-E. VRRP-E supports only the VE interface type.
Enter no debug vrrp all with to disable all VRRP debugging.
Enter no debug vrrp followed by specific events or packet parameters to remove a specific VRRP
debugging configuration.
Examples
To set debugging on sent and received packets for a 10-gigabit Ethernet interface that has an
rbridge-id/slot/port of 121/0/50:
switch# debug vrrp packets interface tengigabitethernet 121/0/50
To set debugging for a session for a VRRP virtual group called vrrp-group-25:
switch# debug vrrp session 25
See Also