Timers (bgp) – Brocade Network OS Command Reference v4.1.0 User Manual
Page 1361
Network OS Command Reference
1323
53-1003115-01
timers (BGP)
2
timers (BGP)
Adjusts the interval at which BGP KEEPALIVE and HOLDTIME messages are sent.
Synopsis
timers {keep-alive keepalive_interval hold-time holdtime_interval}
no timers
Operands
keep-alive
Sets the interval for KEEPALIVE messages.
keepalive_interval
The KEEPALIVE interval in seconds. Range is from 0 through 65535.
Default is 60.
hold-time
Sets the interval for HOLDTIME messages.
holdtime_interval
The HOLDTIME interval in seconds. Range is from 0 through 65535.
Default is 180.
Defaults
See Operands.
Command Modes
BGP configuration mode
Description
Use this command to adjust the interval at which BGP KEEPALIVE and HOLDTIME messages are
sent.
Usage Guidelines
The KEEPALIVE and HOLDTIME message interval is overwritten when the fast-external-failover
command takes effect on a down link to a peer.
You must enter a value for keep-alive before you can enter a value for hold-time. Both values must
be entered.
Use the no timers command to clear the timers.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# timers keep-alive 120 hold-time 360
See Also