Support – Brocade Network OS Command Reference v4.1.0 User Manual
Page 1304
Advertising
1266
Network OS Command Reference
53-1003115-01
support
2
support
Enables or disables the first-fault data capture (FFDC).
Synopsis
support ffdc
no support ffdc
Operands
ffdc
Enables FFDC.
Defaults
FFDC is enabled.
Command Modes
Global configuration mode
Description
Use this command to enable FFDC.
Usage Guidelines
This command is supported only on the local switch.
This command is not supported on the standby management module.
Enter no router ffdc to disable FFDC. When disabled, the daemon does not capture any data, even
when a message with FFDC attributes is logged.
Examples
To enable FFDC:
switch(config)# support ffdc
To disable FFDC:
switch(config)# no support ffdc
See Also
Advertising