Brocade Network OS Command Reference v4.1.0 - Manual (Page 463)

Network OS Command Reference 425
53-1003115-01
lldp iscsi-priority
2
lldp iscsi-priority
Sets the priority that will be advertised in the DCBX iSCSI TLV.
Synopsis lldp iscsi-priority value
no lldp iscsi-priority
Operands value Specifies the priority value. Valid values range from 0 through 7.
Defaults Priority value is 4.
Command Modes Interface subtype configuration mode
Description Use this command to specify the priority that will be advertised in the DCBX iSCSI TLV. The iSCSI
priority setting is used to configure the priority that will be advertised in the DCBX iSCSI TLV for a
specific interface.
Usage Guidelines Enter no lldp iscsi-priority to return to the default setting.
Examples To set the iSCSI priority value to 5 on a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# lldp iscsi-priority 5
See Also interface, lldp dcbx-version, lldp disable, lldp profile