Brocade Network OS Command Reference v4.1.0 - Manual (Page 467)

Network OS Command Reference 429
53-1003115-01
logging auditlog class
2
logging auditlog class
Sets the severity levels for the audit log class.
Synopsis logging auditlog class class
no logging auditlog class class
Operandsclass Specifies the class name of the audit log. Valid classes are
CONFIGURATION, FIRMWARE, and SECURITY.
Defaults CONFIGURATION, FIRMWARE, and SECURITY audit log classes are enabled.
Command Modes Global configuration mode
Description Use this command to set the class for the audit log.
Usage Guidelines This command is supported only on the local switch.
This command is not supported on the standby management module.
The total message storage available is 2048 messages.
Enter no logging auditlog class class to remove the audit logging for the specified class.
Example To enable the configuration class
switch(config)# logging auditlog class CONFIGURATION
See Also clear logging auditlog, clear logging raslog