Error-disable-timeout enable – Brocade Network OS Command Reference v4.1.0 User Manual
Page 298
260
Network OS Command Reference
53-1003115-01
error-disable-timeout enable
2
error-disable-timeout enable
Enables the timer to bring the interface out of the error-disabled state.
Synopsis
error-disable-timeout enable
Operands
None
Defaults
None
Command Modes
Protocol Spanning Tree configuration mode
Description
Use this command to enable the timer to bring the interface out of the disabled state.
Usage Guidelines
When the Spanning Tree Protocol (STP) Bridge Protocol Data Unit (BPDU) guard disables a port,
the port remains in the disabled state unless the port is enabled manually. This command allows
you to enable the interface from the disabled state.
If xSTP is enabled over VCS, this command must be executed on all the RBridge nodes.
Examples
To bring the interface out of the disabled state:
switch(conf-rstp)# error-disable-timeout enable
See Also