Brocade Network OS Command Reference v4.1.0 - Manual (Page 615)

Network OS Command Reference 577
53-1003115-01
qos dscp-traffic-class
2
qos dscp-traffic-class
Applies a defined DSCP-to-Traffic-Class map to an interface,
Synopsis qos dscp-traffic-class name
no qos dscp-traffic-class
Operands name Name of DSCP-to-Traffic-Class map
Defaults DSCP-to-Traffic-Class map is not enabled on the interface.
Command Modes Interface subtype configuration mode
Description Use this command to apply a QoS DSCP-to-Traffic-Class map defined by the qos map
dscp-traffic-class name command to a specific interface.
Usage Guidelines Enter no qos dscp-traffic-class while in the interface mode to remove the DSCP-to-Traffic-Class
map from the interface.
Examples To apply a configured DSCP-Traffic-Class map named test to a specific interface, enter
qos dscp-traffic-class name while in the interface configuration mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# qos dscp-traffic-class test
To remove a configured DSCP-Traffic-Class map named test from a specific interface, enter no qos
dscp-traffic-class while in the interface configuration mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# no qos dscp-traffic-class
See Also interface, qos map dscp-traffic-class, show qos maps dscp-traffic-class