Show diag status – Brocade Network OS Command Reference v4.1.0 User Manual
Page 775
Network OS Command Reference
737
53-1003115-01
show diag status
2
show diag status
Displays the currently diagnostic test status on one or all slots in the system.
Synopsis
show diag status [rbridge-id rbridge-id] [slot slot-id]
Operands
rbridge-idrbridge-id
Specifies the RBridge ID of the switch to display.
slot slot_id
Specifies the slot ID. This is mandatory for slot-based systems only.
Defaults
If an RBridge ID is not specified, diagnostic tests for all blades in the system are displayed.
Command Modes
Privileged EXEC mode
Description
Use this command to display currently running diagnostic tests on a specified switch.
Usage Guidelines
None
Examples
To automatically display current diagnostic status in the console:
switch# show diag status rbridge-id 1
Slot M2 [2]: DIAG runs 'NONE'
Slot S1 [3]: DIAG runs 'NONE'
Slot S2 [4]: DIAG runs 'NONE'
Slot S3 [5]: DIAG runs 'NONE'
Slot L4 [10]: DIAG runs 'NONE'
rbridgeId 1
To display the diagnostic status when POST is running on the LC or SFM using the slot ID:
switch# show diag status rbridge-id 233 slot L1
Slot L1 [7]:DIAG runs ‘turboramtest’
rbridgeId 233
switch# show diag status slot L1
Slot L1 [7]: DIAG runs ‘turboramtest’
rbridgeID 233
See Also