Brocade Network OS Command Reference v4.1.0 - Manual (Page 1374)

1336 Network OS Command Reference
53-1003115-01
usb remove
2
usb remove
Removes a file from an attached USB device.
Synopsis usb remove directory directory file file
Operands directory directory Specifies one the name of the directory where the file you want to remove
is located. Valid USBstorage directories are /firmware, /firmwarekey,
/support, and /config.
file file Specifies the name of the file to be removed.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to remove a directory or a file from an attached USB device.
Usage Guidelines This command is executed on the local switch. The USB device must be enabled before this
function is available.
This command is supported only on the local switch.
This command is not supported on the standby management module.
Examples To remove a configuration file from a USB device attached to the local switch:
switch# usb remove directory config file startup-config.backup
See Also usb, usb dir