Snmp-server contact, P-server contact,snmp-ser, Snmp-server contact,snm – Brocade Network OS Command Reference v4.1.0 User Manual
Page 1262: Nmp-server contact, host, snmp-ser
1224
Network OS Command Reference
53-1003115-01
snmp-server contact
2
snmp-server contact
Sets the SNMP server contact string.
Synopsis
snmp-server contact string
no snmp-server contact string
Operands
string
Specifies the server contact. You must enclose the text in double quotes if
the text contains spaces.
Defaults
The default contact string is “Field Support.”
Command Modes
Global configuration mode
Description
Use this command to set the SNMP server contact string.
Usage Guidelines
Enter no snmp-server contact string to restore the default values.
Examples
To set the SNMP server contact string to “Operator 12345”:
switch(config)# snmp-server contact “Operator 12345”
To set the SNMP server contact string to the default of “Field Support”:
switch(config)# no snmp-server contact
See Also
show running-config snmp-server, snmp-server community, snmp-server location,
snmp-server user, snmp-server v3host