Lenze EVF9383 - Manual (Page 173)

Operating mode
Vector control
6.8
6.8.2
l
6.8−9 EDSVF9383V EN 7.1−04/2012
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0087
s
Mot speed à 50 {1 rpm} 36000 Rated motor speed
à depending on C0086
l Motor selection in C0086 set
the corresponding rated motor
speed in C0087
l Change of C0087 sets
C0086 = 0
^ 6.6−1
C0088
s
Mot current à 0.5 {0.1 A} 1000.0 Rated motor current
à depending on C0086
l Motor selection in C0086 sets
the corresponding rated motor
current in C0088
l Change of C0088 sets C0086 =
0
^ 6.6−1
C0089
s
Mot frequency à 10 {1 Hz} 5000 Rated motor frequency
à depending on C0086
l Motor selection in C0086 sets
the corresponding rated motor
frequency in C0089
l Change of C0089 sets
C0086 = 0
^ 6.6−1
C0090
s
Mot voltage à 0 {1 V} 1000 Rated motor voltage
à depending on C0086
l Motor selection in C0086 sets
the corresponding rated motor
voltage in C0090
l Change of C0090 sets C0086 =
0
^ 6.6−1
C0091
s
Mot cos phi à 0.50 {0.01 } 1.00 Motor cos j
à depending on C0086
l Motor selection in C0086 sets
the corresponding motor cos
j
in C0091
l Change of C0091 sets
C0086 = 0
^ 6.6−1
C0092
s
Mot Ls à 0.00 {0.01 mH} 6553.50 Motor stator inductance
à Value is determined by motor
parameter identification from
C0088, C0089, C0090 and
C0091
à Motor selection in C0086 sets
corresponding stator
inductance value in C0092
^ 6.6−1
C0148
s
ident run 0 0 WRK
stop Ready Motor data identification
1. Inhibit controller, wait until
drive has stopped
2. Enter the correct values of the
motor nameplate into C0087,
C0088, C0089, C0090, C0091
3. Set C0148 = 1, confirm with
v
4. Enable controller
The identification
– starts,
c goes off. The
motor "whistles" but does
not rotate!
– lasts approx. 1 ... 2 min
– is completed when
c is lit
again
5. Inhibit controller:
^
6.6−15
1 WRK run Start identification