Rockwell Automation 1756-RMxx ControlLogix Enhanced Redundancy System User Manual - Manual (Page 127)

Rockwell Automation Publication 1756-UM535D-EN-P - November 2012 127
Configure the Redundancy Modules Chapter 6
Export All
Use this feature to automatically export all the available event log data for events
in both of the redundancy modules of the redundant chassis pair.
We recommend that you use this feature when troubleshooting system related
anomalies, where the location of a fault could have occurred a lengthy period of
time before the current event.
Complete these steps to export event log data for a single event.
1. Launch RSLinx Classic communication software and browse to the
redundancy modules.
2. Right-click the primary redundancy module and choose
Module Configuration.
3. On the Event Log tab, click Export All.
4. Click OK.
5. Select the redundancy module in the partner redundant chassis.
6. Complete these steps on the Export Event Log dialog box.
a. Specify a file name and location or use the default name and location.
b. Check CSV (Comma-Separated Value).
c. Check Export Diagnostic Data.
d. Check Include Extended Information.
TIP If the redundancy modules are not available in RSLinx Classic software after
a fault, you must apply the recovery method indicated by the module
before attempting to export the Event Log data.
TIP If you are sending the exported Event Log files to
Rockwell Automation Technical Support, you must use the CSV
file type.
TIP If you are sending the exported Event Log files to
Rockwell Automation Technical Support, include the diagnostic
data and extended information.
If you include this data, Rockwell Automation Technical Support
can analyze module and system failures more effectively.