Program logic to run after a switchover – Rockwell Automation 1756-RMxx ControlLogix Enhanced Redundancy System User Manual User Manual
Page 170
Advertising
170
Rockwell Automation Publication 1756-UM535D-EN-P - November 2012
Chapter 7
Program the Redundant Controller
Program Logic to Run After a
Switchover
If your application requires certain logic or instructions to be executed after a
switchover, then use programming and tags similar to that shown in this example.
Figure 52 - Precondition Used to Run Logic After Switchover - Ladder Logic
Add your switchover-dependent instructions here.
Advertising