Changing module settings, Stopping a manual run, Clearing run data – Bio-Rad ChromLab™ Software User Manual
Page 111: Saving a manual run
Running an Experiment
User Guide
| 109
Changing Module Settings
Tip:
For some modules, you must stop the pumps before you can change the
settings.
To change module settings
1.
In the fluidic scheme, double-click a module.
2.
In the dialog box that appears, edit module options.
3.
Click Apply (where necessary).
Stopping a Manual Run
To stop a manual run
Click Stop in the System Pump dialog box.
Clearing Run Data
A manual run must be cleared before you can run a method. You can clear the data
and start a new manual or method run.
To clear run data
Click Clear in the System Control window toolbar.
Saving a Manual Run
Saving a manual run saves the chromatographic data and run log. You can open the
saved chromatogram in the Evaluation window.
To save a manual run
Click Save on the System Control window toolbar to save manual run data.
Important:
If you do not save the manual run before you switch to a method
run, the manual run data are lost.