Bio-Rad ChromLab™ Software - Manual (Page 217)

Customizing the Trace Table Display
User Guide | 215
Manually Setting the Injection Point (x Alignment)
You can manually set the injection point for any run, including a run displayed in a
trace comparison. The injection point is saved with the run (the x = 0 point). A
change to the injection point in one view affects other views that include the run.
To set the injection point for a run manually
1. Select Analysis > Set Injection Point.
2. In the Set Injection Point dialog box, type the new injection point.
3. If several runs are open in the same window, select a run on the Run menu.
4. Click Apply to align the data according to the setting you typed or click Reset to
restore the original setting.