Bio-Rad ChromLab™ Software - Manual (Page 172)

6 | Creating a Method
170 | NGC Chromatography Systems and ChromLab Software
about priming your system.
9. Select a pump head type. To set the control parameters see Control Flow Tab
on page 72 .
10. Under Buffer Selection, select buffers for each inlet line or select the buffer
system and pH if you are using the buffer blending module. See also Buffer
Selection on page 133 .
11. Click Rename Ports to change the names Buffer A and Buffer B to more
descriptive terms.
Names you select here appear in the method report.
Adding Phases
When you add a phase to a method, the parameters for the added phase appear in
the Method Outline pane.
To add phases to a method
1. Drag a phase from the Phase Library pane to a position in the Method Outline
pane.
2. Continue adding phases until the method is complete.
3. Save the method.
Editing Methods and Phases
Changes you make to the Method Settings phase affect the entire method.
Changes you make to any other phase apply only to that phase.
To edit phases in the Phase Parameters pane
1. With the Phase Parameters tab selected, select a phase in the method’s
Method Outline pane.
The settings for the selected phase appear in the Phase Parameters pane.
2. Edit the phase parameter settings.