Bio-Rad ChromLab™ Software - Manual (Page 156)

5 | Method Editor
154 | NGC Chromatography Systems and ChromLab Software
System Preparation Parameters
This phase removes storage solution and fills the tubing and system inlet line with
buffer solution before a run. The inlets, outlets, and column positions to be prepared
are selected, and the system is filled with the appropriate buffer solution. Because
each inlet port can be plumbed to a different buffer or sample, multiple buffers and
samples can be used in each phase.
Note: System Preparation must be run as the only type of phase in the
method. You can add several System Preparation phases to the method if
cycling between multiple solutions is required. Bio-Rad recommends that you
save System Preparation as a separate method.