Motorola MC68VZ328 - Manual (Page 124)

7-14 MC68VZ328 User’s Manual
Programming Model
7.3.2 DRAM Control Register
The DRAM control (DRAMC) register is used to control the operation of the DRAM controller. The bit
position and values are shown in the following register display. The details about the register settings are
described in Table 7-7.
DRAMC DRAM Control Register 0x(FF)FFFC02
BIT 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 BIT 0
EN RM BC1–0 CLK EDO PGSZ MSW LSP SLW LPR RST DWE
TYPE rw rw rw rw rw rw rw rw rw rw rw rw rw rw
RESET
0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 0
0x0000
Table 7-7. DRAM Control Register Description
Name Description Setting
EN
Bit 15 Master DRAM Controller Enable—This bit
enables and disables the DRAM controller. 0 = Disable the DRAM controller.
1 = Enable the DRAM controller.
RM
Bit 14 Refresh Mode—This bit sets the refresh mode. 0 = CAS-before-RAS refresh mode.
1 = Self-refresh mode.
BC1–0
Bit 13–12 Page Access Clock Cycle (Fast Page
Mode)—These bits determine the number of
additional clocks for the second and subsequent
accesses within a Fast Page Mode read cycle
after the first data word.
1
00 = 1 additional clock (2 clocks/transfer).
01 = 2 additional clocks (3 clocks/transfer).
10 = 3 additional clocks (4 clocks/transfer).
11 = 4 additional clocks (5 clocks/transfer).
CLK
Bit 11 Clock—This bit selects the clock that is provided
to the refresh timer. 0 = CLK32 (Period A) is selected.
1 = System clock (Period B) is selected.
EDO
Bit 10 Extended Data Out—This bit selects the page
access mode for LCD DMA DRAM accesses.
This bit should only be set if the DRAM supports
EDO RAM transfers. When the EDO bit is set,
BC0 and BC1 do not affect the number of clocks
for LCD DMA DRAM accesses. EDO RAM mode
is the fastest LCD DMA transfer mode. 0 = Fast Page Mode mode is selected.
1 = EDO enables 1 clock for each LCD DMA data
word transfer after the first word transfer.
Bits BC1–0 are ignored.
PGSZ
Bits 9–8 Page Size—This field determines the page size
in the word for Fast Page Mode mode access. 00 = 256
01 = 512
10 = 1,024
11 = 2,048
Reserved
Bits 7–6 Reserved These bits are reserved and should be set to 0.
MSW
Bit 5 Slow Multiplexing—Setting this bit adds a sys-
tem clock for DRAM address multiplexing, which
allows for a heavily loaded A/DMA bus. Setting
this bit causes an additional wait state for all core
accesses and the first LCD DMA word access. 0 = Normal address multiplexing.
1 = Slower address multiplexing.