Metric Halo Mobile I/O - Manual (Page 152)

MIO Console Overview
152
• WCx256 (44/48) directs Mobile I/O to clock off of an external 256fs Clock Source at single rate (e.g.
fs = 32k-50k)
• WCx256 (88/96) directs Mobile I/O to clock off of an external 256fs Clock Source at double rate (e.g.
fs = 64k-100k)
• ADAT (44/48) directs Mobile I/O to clock off of the incoming ADAT stream and run at single rate. All 8
ADAT channels are available. You will generally want to select this source if you intend to use ADAT
input.
• ADAT (88/96) directs Mobile I/O to clock off of the incoming ADAT stream and run at double rate.
Please note that although it is possible to clock the Mobile I/O via SMUX, the ADAT input will not be
functional.
• DigIn (44/48) directs Mobile I/O to clock off of the selected stereo digital input at single rate (e.g. fs
= 32k-50k). This allows operation of the digital input without SRC, and from devices that must supply
clock.
• DigIn (88/96) directs Mobile I/O to clock off of the selected stereo digital input at double rate (e.g. fs =
64k-100k). This allows operation of the digital input without SRC, and from devices that must supply
clock.
The choices for LIO-8 and ULN-8 are:
Figure 11.19: Clock Source Pop-up Menu for LIO-8 and ULN-8
• Internal directs the LIO/ULN-8 to use its internal clock. You must select this if you want to set the sample
rate from the LIO/ULN-8. If any other clock source has been selected, the console will not allow you to
change the sample rate since the sample rate is determined by the external clock source.
• WC (44/48) directs the LIO/ULN-8 to clock off of an external Word Clock Source at single rate (e.g.
fs = 32k-50k)