Metric Halo Mobile I/O - Manual (Page 306)

+DSP
306
instantaneously. In between values cause the filter to interpolate changes in the parameters at a
faster or slower rate.
Gain
[-100, 27] dB
Sets the output gain of the filter.
NC SVF
• Synopsis: Numerically Controlled State Variable Filter
• Category: EQ, Synth Effect, Building Blocks
• Channels: 1
Description:
NC SVF is a monophonic process block that simultaneously applies multiple filters (high pass, low
pass, band pass and notch) to the input signal. Each filter is available on a different output of the
process block.
The filter parameters are driven by the 2 control inputs (Cutoff and Resonance) and are fully interpolat-
ed, so you can modify them at audio rates without causing any glitches in the audio being processed.
The Cutoff input allows you to set the center/cutoff frequency of the various filters. The Resonance
input allows you to control the resonance at the cutoff frequency. The Resonance control signal is the
inverse of the Q factor of the filter (1/Q). Larger Q's will increase the peaking at the cutoff frequency.
MIOSimplePitchShifter
• Synopsis: Simple Pitch Shifter
• Category: Synth Effect, Building Blocks
• Channels: 1
Description:
The MIOSimplePitchShifter is a monophonic process block that shifts the pitch of the input signal by
the specified number of half-steps (12 half-steps per octave).
The MIOSimplePitchShifter provides one parameter (
Steps
), which is the amount of pitch shift to
apply to the signal. The shift parameter has a range of -24 half-steps (-2 Octaves) to +24 half-steps (+2
Octaves), and may take on any fractional value in the range.
There is a small amount of effective delay on the pitch shifted signal, but it is generally not noticable
when the shifted signal is summed back with the original signal. Depending upon the frequency of
the input signal there may be a small amount of AM modulation in the output signal. This will appear
as apparent tremolo on the output.
Parameters:
Steps
[-24, 24]
Sets the amount of pitch-shift applied to the input in half-steps. This parameter supports mi-
cro-tonal shifts.
HaloVerb
• Synopsis: Reverb for Mobile I/O
• Category: Reverb
• Channels: 1, 2
Description: