Metric Halo Mobile I/O - Manual (Page 245)

DSP Implementation Guide
245
Figure 15.11: Completing the Connection
Figure 15.12: Making a Mult
After everything is placed and wired up, you will need to ensure that you have routed the output of your
signal processors to the appropriate port on the output side of the graph. When you are done, you will have
a complete graph. For example:
Figure 15.13: Connecting the Output
As you can see, once the output of the final plug-in was connected to the output port, the input-to-output
connection was removed, and you are now listening to the processing chain.
The graph is continuously modifiable. You can drag the plug-ins around as you like, and you can add new
plug-ins, even while you are processing audio with the existing graph. You can make and break connections
as you please.
There is no routing delay within the plug-in graph. So if you make mults with different plug-in paths on each
side of the mult, the two paths will remain time-aligned. This allows you to configure parallel processing paths
without the virtually impossible task of time-aligning the parallel paths.
At this point, you will want to be able to control each plug-in's parameters. Double-click on any plug-in to
view its UI as described
previously .