Metric Halo Mobile I/O - Manual (Page 201)

201
13. Routing Examples
Introduction
This document provides a hands-on description of how to configure the mixer and router for a somewhat
complex tracking situation. This document is only for 2d Expanded units. You can compare this document
to corresponding document (
Routing Applications for Unexpanded Units ) for un-expanded units to see how
much easier the process has gotten with the 2d Card and the v.5 mixer.
Effects for tracking
Headphones
OutBoard Effects/Instruments
Big Monitors
AES/EBU
Small Monitors
Microphones
Figure 13.1: Example ULN-2 Setup
In this section we will go step by step through an application that is possible with a ULN-2 configured as
shown in illustration Example ULN-2 Setup above. After reading this section you should have a feel for how
to apply Mobile I/O’s routing and mixing capabilities.
Many performers (especially singers) find it easier to get a good take if they have some sweetening effects in
their headphone mix while tracking. These will usually be temporary effects and will not necessarily make it
into the final mix but they can make the difference between a good take and a bad take.