Metric Halo Mobile I/O - Manual (Page 208)

Routing Examples
208
can unmute each channel and set its send level to the reverb. If you want it to match the levels of the dry
headphone mix, you can ensure that all the sends are Post Fader and all the send faders are set to unity gain. If
you would rather set the reverb send levels independently of the dry mix, you can make the sends Pre Fader.
Tweak the HaloVerb settings to taste. Notice that even if you set the Direct dB parameter back to 0 dB there
is no phasing introduced, because the v.5 mixer is absolutely phase coherent, even with routing between
multiple busses.
Your final configuration will look something like this:
Figure 13.12: Final Configuration
If you want to use this example as a tracking set up, choose Save As... from the file menu. This brings up a
standard Macintosh save dialog and allows you to save the entire state of MIO Console as a setup document.
Controlling Multiple Monitors
You can use the Monitor Controller features of Mobile I/O to set up multiple monitor paths and easily switch
between them. The Monitor Controller is an intelligent router and volume controller that was designed specif-
ically to manage monitoring systems.