Metric Halo Mobile I/O - Manual (Page 362)

Glossary
362
Figure 321: Phase Cancellation
Post Means “after”. Common uses:
• Post-fader: After the fader. A post-fader meter would show the level of
an audio signal including the boost or cut of the fader.
• Post-insert: After the insert. A post-insert direct out would send wet
audio.
PPM meter Peak Program Meter. This type of audio meter features a fast response, al-
lowing you to see peak signal level and catch potential overs quickly.
Pre Means “before”. Common uses:
See also Mic Pre
• Pre-fader: Before the fader. A pre-fader meter would show the level
of the audio before the fader, so the meter’s display would not show
boost or cut from the fader.
• Pre-insert: Before the insert. A pre-insert direct out would send dry
audio.
R
RCA A two conductor connector, sometimes called a phono connector. RCA con-
nectors use a two conductor (often coaxial) cable to carry unbalanced sig-
nals, and are wired with signal to the center pin and ground to the ring. In-
puts and outputs are both on female (jacks) and interconnect cables are male
to male (plugs). Extensions are male to female.
S
Scene A “picture” of your MIO Console setup. All your routing, fader levels, DSP
plug-ins, etc. are saved so that they can be quickly recalled. This can be done
by saving from MIO Console using “File/Save” and “File/Open” or from your
DAW using MIOConsoleConnect.