Metric Halo Mobile I/O - Manual (Page 346)

ULN-R Installation Guide
346
Figure I.5: 7/16” Standoffs
• 3) Phillips head screws
Figure I.6: Phillips Head Screw
The ULN-R Mic Pre (Ch. 5-8) kit includes the following parts:
• 1) 4 channel ULN-R mic pre board
• 1) 20 pin ribbon cable jumper
• 4) Phillips head screws
The Ch. 1-4 kit must be installed for the Ch 5-8 kit to function!
To install the ULN-R mic pre option in the LIO-8 you will need:
• #1 Phillips screwdriver
• 7/16” nutdriver (Ch. 1-4 kit only)
• silicone caulk
Please familiarize yourself with the parts and instructions before opening the LIO-8.
Be sure to discharge any static energy on your body before touching the interior of the LIO-8.
Installing the mic pres:
1. Remove the six screws from the top of the case:
Figure I.7: Top Screw Placement