Metric Halo Mobile I/O - Manual (Page 220)

Routing Examples
220
Figure 13.32: Setting the VST Outputs
Next we need to create an input mapping for FW 1/2, so that we can record the mix back into Cubase.
Figure 13.33: Setting the VST Inputs
The final step is to assign your audio in Cubase’s mixer:
• Set the inputs on your 18 playback channels to “No Bus”.
• Set the outputs sequentially (Audio 1 to Mono Out 1, Audio 2 to Mono Out 2, etc).
• Set the input of your stereo mixdown channel to “Stereo In”.
• Set the output of your stereo mixdown channel to “No Bus”.