Mio a/b switch (linear), Mio a/b switch (lpf), 301 mio a/b switch (lpf) – Metric Halo Mobile I/O User Manual

Page 301

Advertising

+DSP

301

Master Bypass

{On, Off}

When enabled, bypasses the process so that the output is the same as the input.

MIO A/B Switch (Linear)

• Synopsis: A/B Switch - Linear Interpolation
• Category: Signal Switch, Building Blocks
• Channels: 2->1, 4->2, 6->3, 8->4, 10->5, 12->6, 14->7, 16->8

Description:

The MIO A/B (Linear) is a multichannel process block that allows you to crossfade between multichan-
nel input ports. The MIO A/B (Linear) implements a mono channel input port selector switch. Since
the switch implements cross-fading between its inputs, it can also be used as a constant amplitude
mixer. The

Glide

parameter controls how quickly the gain coefficient changes. This implementation

of the switch interpolates the gain linearly. This means that the gain changes at a constant rate per
sample as the internal gain approaches the selected gain.

Parameters:

A Blend

[0, 1]

Sets the portion of the output that comes from the first input port when the

A/B

switch is turned on.

The portion of the output that comes from the second input port is the complement of this value.

B Blend

[0, 1]

Sets the portion of the output that comes from the first input port when the

A/B

switch is turned off.

The portion of the output that comes from the second input port is the complement of this value.

Glide

[0, 1]

Sets the rate that the process uses to change the internal values of its cross-fade parameter. Large
values lead to faster changes. A value of 1 will cause the gain to change instantly, but could lead
to clicks. Very small values will cause the gain change to take place very slowly, which can be
used to provide a triggerable, automatic crossfade.

A/B

{On, Off}
Chooses the Port 1 gain from the

A Blend

(on) or

B Blend

(off) parameters.

Master Bypass

{On, Off}

When bypassed, MIO A/B (1/Linear) will pass the signal from the A port(s) untouched.